New JBR MAZDASPEED 3/6 & CX7 Boost Tubes & Recirculation Hoses in Stock!!

[JBR]

Originally Posted by qwerty4550 Over the weekend I installed a JBR Silicone Turbo Inlet Pipe and JBR Silicone Recirculation Tube. If I push the Recir pipe all the way onto the inlet pipe, it seems like the hose does not fit perfectly onto the BPV. Should I not push the hoses so they sit flush against one another on the TIP side?

Should be fine when the connections are flush.

Here are a few installed picks:







Post a couple of good pics and I'll try and help. The TIP may also need to be rotated a bit. It's tough to say with out seeing it.

Thanks,
Jamie

[qwerty4550]

Originally Posted by jbarone Should be fine when the connections are flush. Here are a few installed picks: Post a couple of good pics and I'll try and help. The TIP may also need to be rotated a bit. It's tough to say with out seeing it. Thanks, Jamie

Here is a picture of where the recirc hose meets the bpv. Cell phone pic, so hopefully it isn't too bad.